Used to glue EPS boards to stable, mineral bases. The product is classified as mineral gluing ground, with very good gluing properties and very good initial adhesion. The glue is an integral element of product ranges in Greinplast A, T, G, X, S, H insulation systems (according to applicable ATâs) and Greinplast EPS (according to ETA).
Packaged in 25kg containers.
Preparation of dry set mortar: Empty the package (25 kg) into 6,0-6.5 l of clean, cool water and stir well until a smooth mass is obtained. The volume of added water depends on the weather conditions and base absorbability. The mortar achieves its full working properties in 5 minutes, after which it should be stirred again. The usability time of mortar mixed with water depends on ambient conditions, however, it is not longer than 2 hours.
Laying EPS panels: Glue on ESP panels should be applied along the edges, in belts at a minimum width of 3-4 cm, and on the remaining surface in circles at diameters 8-12 cm. EPS panels should be put on the wall immediately and pressed until even surface with the neighbouring panels is achieved. After placement, the overall surface of the applied gluing mass should cover at least 40% of the panel. Gluing EPS panels with the application of only glue circles is not allowed. Do not press glued panels again and do not move them after 10 minutes.
.png)
.png)
.png)
.png)
.png)
.png)
The façade surface should be shielded against rain, wind and excess sunlight until it is completely dry. Do not carry out any works when the base temperature is lower than +5°C. The building thermal insulation design specifies the necessity for carrier pins and their type (usually, with a load-bearing base up to 12 meters, they are not required). Glue in its autumn-spring version (as described on the unit package) should not be used in temperatures higher than +15°C. The product contains pigment. Do not use to sink reinforcement meshes. Any attempts to change the composition of the product are not allowed, as they may considerably reduce its quality.
Information contained in the manual help ensure the optimal use of the product, however, it does not create any legal liability of the Manufacturer, due to the fact that the conditions of use remain outside of its control. Glue consumption depends on the evenness degree at the base.
