Used in pointing of "Pro-Monta" boards, and to glue drywall boards and other gypsum elements, EPS decorative elements to walls, inside buildings. The use of synthetic gypsum in the chemical composition allows a continuous maintenance of glue endurance parameters. The product can be applied on mineral bases, such as: cement, cement-lime and gypsum plasters, drywalls and "Pro-Monta" boards, concrete, cellular concrete etc.
Packaged in 20kg containers.
Preparation of mass: Empty the package (20 kg) into ca. 10 l of clean, cool water and stir well until a smooth mass is obtained. The volume of added water depends on the weather conditions and base absorbability. The glue achieves its full working properties in 3 minutes, after which it should be stirred again. Clean tools and containers must be used in material preparation. Each time, only such amount of glue should be prepared that will ensure its consumption in 45 minutes. Unused, hardening material cannot be diluted in water again.
Execution: Stainless tools must be used in glue application. When drywall panels are used, apply glue on panels in blobs located no farther apart from each other than 30-35 cm. The minimum thickness of applied material should be around 1,5 cm. Then, put the panel against the wall and press it to the base. Panel locations can be corrected within 5 minutes after their placement.
.png)
The temperature of the base and its surroundings during the application and drying should not be lower than +5°C and higher than +30°C. The optimal application temperature is +20°C. Secure surfaces exposed to contamination; any stains should be removed before drying. The specified processing times may be subject to considerable variations under the influence of adverse thermal and moisture conditions.
Information contained in the manual help ensure the optimal use of the product, however, it does not create any legal liability of the Manufacturer, due to the fact that the conditions of use remain outside of its control. We do not accept any responsibility if the material is combined with products from other Manufacturers. Glue consumption depends on the evenness degree at the base.
